DIY STUDDED ROPE BRACELET

A few fleeting ‘omg what am I doing’ thoughts and a whole lot of enthusiasm for working harder – oh and relief that no matter how old I get, my boyfriend will always be 4 years older. Yay! On an unrelated note, my addiction to anything involving rope or studs has spawned the studded rope bracelet. Read on to see how diy bracelets with string!

You need:

Cotton Rope
Gold End Caps
Gold Lobster Clasps
Jump rings
Pyramid studs
Super glue
Jewelry pliers

How to:

Measure the rope to fit your wrist.

Cut to size (addicted to fancy scissors).

Put some glue in the end cap.

Press an end cap onto both ends of the rope, making sure to remove the tape from the ends of the rope (if there is any) and pushing it in so you get a snug fit.

Using your pliers, attach the jump ring to one end and the jump ring and lobster clasp to the other end.

Space your studs out across the rope to determine where to put them.

Put some glue into the stud and then press it onto the rope, clamping down the prongs and allowing to dry overnight.

Et voila!

Share this article to your friends.